OC200 5.1.7 no longer reporting Mesh link strengths?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200 5.1.7 no longer reporting Mesh link strengths?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 5.1.7 no longer reporting Mesh link strengths?
OC200 5.1.7 no longer reporting Mesh link strengths?
2022-04-17 14:50:30 - last edited 2022-04-18 01:20:08
Model: OC200  
Hardware Version: V1
Firmware Version: 1.15.2 Build 20220323 Rel.60717

This worked just fine with 5.0.30, but after upgrading to 5.1.7, it has stopped.  Signal dBm are no longer reported when scanning for alternate mesh links.  See below

 

 

also, thanks for the1-button upgrade procedure via cloud!  Much easier than upgrading my other Docker based controller!

<< Paying it forward, one juicy problem at a time... >>
  0      
  0      
#1
Options
1 Accepted Solution
Re:OC200 5.1.7 no longer reporting Mesh link strengths?-Solution
2022-04-17 19:17:48 - last edited 2022-04-18 01:20:08

  @d0ugmac1 

 

try dragging this to the right 

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:OC200 5.1.7 no longer reporting Mesh link strengths?-Solution
2022-04-17 19:17:48 - last edited 2022-04-18 01:20:08

  @d0ugmac1 

 

try dragging this to the right 

 

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 466

Replies: 1

Related Articles