EAP110 Ceiling mount cant connect to ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP110 Ceiling mount cant connect to ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP110 Ceiling mount cant connect to ap
EAP110 Ceiling mount cant connect to ap
2022-05-07 13:59:27
Model: EAP110  
Hardware Version: V4
Firmware Version:

My current setup is Cpe510-ap(House A) to Cpe510-bridge(House B) then connected to EAP110 Ceiling via lan cable. When connecting i get ip configuration failed error. When using old eap110 outdoor it connects just fine without any setting. Am i missing something here? Or is my new ap broken?

  0      
  0      
#1
Options
2 Reply
Re:EAP110 Ceiling mount cant connect to ap
2022-05-09 07:42:38

  @KevinL1991 If old EAP110-Outdoor can work, it looks like an issue on new EAP.

 

I guess the problem is on PoE injector. You can try replace the Etherent cable from CPE to this injector. My suggestion is a short Ethernet cable within 2m

 

 

  0  
  0  
#2
Options
Re:EAP110 Ceiling mount cant connect to ap
2022-05-09 15:54:30

  @KevinL1991 

 

Are you using a controller?  If so what version is the controller, the version of the old 110 and what version is the 110 ceiling?  I suspect you have mismatch (ie v4 or lower for the controller and v5 or higher for the new AP).  Update time.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#3
Options