Hi there,

 

I've currently a setup of these equipments on my company:

 

- omada 300 controller.

- er8411 router.

- 1x TL-SG3452X.

- 1x TL-SG3428X.

- 3x TL-SG3428XMP.

 

I have just bought an EAP670 AP for testing purposes and if everything is OK I'll be adding more of them.

 

As for initial configuration I've created 3 VLAN based wifis.

 

- company (VLAN 70)

- security (ipcams) (VLAN 30)

- guest (VLAN 80).

 

For guest network I've created a Client Rate Limit Profile as 1Mpbs up /1Mbps down and after connecting it with my phone and speed-testing, it was correctly rate limited.

 

But instead of  1Mpbs up /1Mbps down per client rate limit, I want to rate limit per-SSID (rate limiting all the connected clients in guest network to a total of  1Mpbs up /1Mbps down and set it as shown here:

 

 

 

And again get connectd through my phone to guest wifi network and ran a speed test again.

 

But unlike the per-client settings working all good, the connection was not rate-limited and the phone was able to use all the bandwith of my WAN connection.

 

Any ideas?