Multi-WAN Setup for ER605 - Policy for Download and Upload
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I need your help setting up my ER605 to meet my business requirement.
Basically, I have TWO ISPs
ISP ABC - Download Speed: 300Mbps, Upload Speed: 10Mbps
ISP XYZ - Download Speed: 50Mbps, Upload Speed: 50Mbps
The actualy primary objective is to use ABC as primary source of download since it has the highest Download Speed, and XYZ should be used as the primary source of Upload since it has the highest upload speed (I dont care about the Download Speed of XYZ, all I need is the Upload).
The Setup I have made so far:
WAN1:
ISP ABC
Upstream Bandwidth: 100000Kbps
Downstream Bandwidth: 100000Kbps
Static IP
Connected
WAN2:
ISP XYZ
Upstream Bandwidth: 100000Kbps
Downstream Bandwidth: 10Kbps (since I dont need the Download speed anyway)
Static IP
Connected
Transmission Control -> Load Balancer:
✅ Enable Load Balancer
🔲 Enable Application Optimized Routing
✅ Enable Bandwidth Based Balance Routing on port(s): WAN1/WAN2
Now when I try it, it doesnt seem to increase the Upload Speed based on Speedtest and Fast.com. Did I do something wrong? Is this even feasible?
Hi @Questy
Thanks for posting in our business forum.
You can take a look at this first. 6..
Possible only when multiple sessions are involved.
Hi @Questy
Thanks for posting in our business forum.
You can take a look at this first. 6..
Possible only when multiple sessions are involved.