DHCP server set ip range over CLI
Hello,
I have a unique network configuration where I would like to write my own software to configure the IP range of several DHCP pools with separate VLANs. I was planning on doing it over SSH however I can't find a way to set the IP range of a specific DHCP pool.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Juniormunk
Thanks for posting in our business forum.
Here's the guide:
https://static.tp-link.com/upload/manual/2023/202307/20230725/1910013378_ER605(UN)2.0_CLI.pdf
You might wanna start reading from this:
- Copy Link
- Report Inappropriate Content
Hi @Juniormunk
Thanks for posting in our business forum.
Here's the guide:
https://static.tp-link.com/upload/manual/2023/202307/20230725/1910013378_ER605(UN)2.0_CLI.pdf
You might wanna start reading from this:
- Copy Link
- Report Inappropriate Content
@Clive_A This doesn't help me any. I am looking for a way to change the available range for example I have a DHCP server for vlan 3 that has an ip-mask of 10.35.39.4 255.255.255.0 and I would like the dhcp hand out IP addresses from 10.35.39.20 to 10.35.39.200
- Copy Link
- Report Inappropriate Content
Hi @Juniormunk
Thanks for posting in our business forum.
Juniormunk wrote
@Clive_A This doesn't help me any. I am looking for a way to change the available range for example I have a DHCP server for vlan 3 that has an ip-mask of 10.35.39.4 255.255.255.0 and I would like the dhcp hand out IP addresses from 10.35.39.20 to 10.35.39.200
If you need to do that, you can only do it from the web GUI.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 224
Replies: 3