Need to introduce pfSense firewall in Omada

Need to introduce pfSense firewall in Omada

Need to introduce pfSense firewall in Omada
Need to introduce pfSense firewall in Omada
2024-08-19 19:57:18
Model: OC300  
Hardware Version:
Firmware Version:

I planing to setup like below -

Internet is giving DHCP ip address to the firewall outside interface

pfSense inside interface and WAN port on Gateway is L3, 10.15.1.1 (pfSense) and 10.15.1.2 (Gateway)\

My vlan 1 is 172.17.1.0/24

I took another interface and made sub interfaces of it for vlan 2

I am able to access internet however, I am unable to access VLAN 1 resources from VLAN 2 even after enabling access on the firewall bi-directional

I am able to ping or access resources of VLAN 2 from VLAN 1.

I configured static route on firewall pointing towards gateway as next hop but I am not getting response.

 

Please help me why I am unable to ping vlan 1 from vlan 2. Its super urgent.

On omada controller I will not able to change anything for VLAN 1 hence using it for device management purpose.

 

  0      
  0      
#1
Options
1 Reply
Re:Need to introduce pfSense firewall in Omada
2024-08-20 07:15:03

Hi  @Zonelab 

 

Thank you so much for taking the time to post the issue on TP-Link community!
To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID is TKID240842348, please check your email box and ensure the support email is well received. Thanks!
Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.
Many thanks for your great cooperation and patience!

  0  
  0  
#2
Options