Has anyone successfully gotten through on port 8080?

Has anyone successfully gotten through on port 8080?

Has anyone successfully gotten through on port 8080?
Has anyone successfully gotten through on port 8080?
2024-11-21 16:07:40 - last edited 2024-11-21 17:01:43
Model: ER7206 (TL-ER7206)  
Hardware Version: V2
Firmware Version: 2.1.2 Build 20240324 Rel.46738

I am trying to connect remotely to the camera built into the Flashforge printer I have which is on port 8080 (192.168.10.110:8080/?action=stream). I can connect locally, but cannot connect remotely. I have set up a vserver rule for it an set up port forwarding. I have a static IP and can see the port is open when checking externally. I am thoroughly confused as to why this is. Any help will be greatly appreciated.

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Has anyone successfully gotten through on port 8080?-Solution
2024-11-21 16:44:44 - last edited 2024-11-21 17:01:43

  @3DScanSTL 

 

remove port trigger config, you only need virtual server

 

Recommended Solution
  0  
  0  
#4
Options
5 Reply
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 16:19:59

  @3DScanSTL 

 

hard to say since you haven't shown any screenshots of your configuration.

 

 

  0  
  0  
#2
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 16:26:19

  @MR.S 

 

I assumed that the image showing port 8080 open from the outside was sufficient to show that the port is open. I can access my NAS just fine. 

 

  0  
  0  
#3
Options
Re:Has anyone successfully gotten through on port 8080?-Solution
2024-11-21 16:44:44 - last edited 2024-11-21 17:01:43

  @3DScanSTL 

 

remove port trigger config, you only need virtual server

 

Recommended Solution
  0  
  0  
#4
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 17:00:44

  @MR.S 

So this is bizarre, I pulled up the link and it first said it wasn’t available, but I set my phone down and after about 15-20 seconds it connected. The throughput is terrible, but I did connect. I had not waited this long previously as I was used to connecting immediately.

  0  
  0  
#5
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 17:09:09

  @3DScanSTL 

 

i use controller so i don't know how it is in stand alone that you use, but all port forwards go lightning fast.. there is no delay at all.

 

 

  0  
  0  
#6
Options

Information

Helpful: 0

Views: 276

Replies: 5

Related Articles