Hello, I am unable to configure IPV6 on my deco. I have a omada system sitting in between my isp modem and deco. On omada system (router + switch + Controller), i get ipv6 assigned from ISP. However,

I had a power outage and my mesh network was not working. Had a solid red light on the main unit (the one connected to the modem) and flashing red on the other units. I followed instructions in this t

Team, I have to publish this in the EN Deco forum cause i didn't get any answer from US Deco forum. I really love this mesh router, but I feel like the TP-Link team has forgotten about it and hasn't d

I have a Raspberry Pie running Home Assistant plugged directly to the Deco x55 and zemismart m1 for smart family use. It will lost connect ~10 seconds and connect back again, I think it should not be

In the attic, there is one Deco X50-5G for internet connection via a SIM card in 4G/5G Router Mode. Three Deco X50 A3000 are positioned one floor below. The X50-5G serves as the main Deco and communic

Hello! I have been running a mesh network at home using a Deco X50-5G as my router (relying on its 5G connection for Internet) and a three-pack of Deco X50s as satellites around the house. The initial