@GRL Thanks for the info. When this thread first started (and because I don't use switch ACLs anymore), out of curiosity I ran a quick test to check packet behavior. The setup was simple: PC --->...

GRL wrote @jra11500 Switch ACLs work without needing an interface on any particular VLAN, since all SG class and better switches are L3 capable they inspect packet headers of anything traversing the...

@Vincent-TP Yesterday I upgraded the controller to the latest pre-release version. Today I tested the topology map to see if the issue persists. I have no trouble now with expanding the client...

@doublemac I just checked the release notes and you might need v6.1 of the controller instead of v6.0. The latest pre-release firmware post was just updated an hour ago.

@doublemac I use SG2008 switches here which are practically the same. As stated earlier, I don't use switch ACLs because gateway ACLs are easier to set up. The latest Omada v6 controller allows IP...

@doublemac For the switch ACLs to work properly, at a minimum you need to have a switch interface enabled on each VLAN, otherwise everything passes through the switch and on to the gateway for...