@Joanlebelle Which switch did you use? Can you share a picture here? Note that the robot vacuum will still need to maintain WiFi connection while in standby mode, which will also consume battery...

@DJ00 Check this article. What to do if my Tapo Camera gets bricked after a firmware update?

@JM99 The camera cannot be installed without WiFi. After the setup, the camera can continue to operate when WiFi and internet are both down. However, if you want to access the camera (watch...

@Damienetjess This camera does not support image inversion due to hardware design constraints that prevent upside-down installation. Tapo C410 is equipped with a PIR sensor, which has a fixed...

@BammBamm I'm afraid this is not supported.

DaleZ wrote @DaleZ I wired around the GFI and all works fine. @DaleZ Is everything alright now? What changes did you make? If the problem persists, I recommend reaching out to the local TP-Link...