@Errefae No, with VR600 you can't do load balancing. It's either DSL port (DSL modem router mode) or WAN/LAN4 port (wireless router mode) you can use at a time. There's a special devices - load...

@Blechaluk As @Liverpool20 mentioned, 2-pack Deco mesh system would be a good solution in your case - like Deco M4 for example. OneMesh doesn't support ethernet bachaul - Q5/A5. Here's how to use...

@Ole_Werner It's not recommended to use a different voltage from that the power supply included in the kit provides. This could lead to a burnt components on the device's PCB due to a wrong voltage....

@Dano187 After resetting the router the default username/password to access its management interface is admin/admin. If you can't see the wireless password, then use an etherrnet cable to connect to...

@Anik2022 First there's a newer FW release for your device, which addresses some vulnerability issues - here. Here's the Parental Controls guide for Archer C20. Here's the Access Control guide for...

@yukkey Archer AX50 has two modes - Router mode and Access Point mode. If you're referring to AP mode use this guide (Case 1) to check if it's properly configured.