@dsl-link If you have Smart Connect enabled - disable it and then you should be able to chose the wireless channel manually.

@Jannek999 The HW version on the bottom sticker is mandatory to determine the proper FW release. In your case if on the bottom sticker says HW v2.0 then you should use this release - Deco M9...

@VijayKapoor You can't have OneMesh between two routers - OneMesh FAQ - Q10. You can add a second RE from this list to expand the existing OneMesh further. 1. In general C6 has the WDS feature, which...

@Hostillius It seems like you need the modem. If you keep your EE smart hub, connect it like it was before. Then connect an ethernet cable from its LAN port to the C6 WAN port (Dynamic IP).

@Giggs11 Yes, you can use the controller software instead of the hardware version. I believe that the mesh network will work with your existing equipment, just you won't be able to configure and...

@FRAGGER In general if everything is properly configured, restarting the main and after that the extended router, should brig back the WDS bridge. But if that happens often to you, I would suggest to...