Hi, I am trying to create a IPSec VPN with a Zscaler DC. The VPN config is fine but it throws a phase 2 error stating "INVALID PROPOSAL" You can see the logs below, these are from Zscaler. I think tha

In the controller logs, the entries appear with a 12 hour timestamp and "am" or "pm". Is there a setting for the controller to use 24 hour time? I can not seem to find it. I read in earlier posts that

Hi everyone, when I add a new device, my gateway (controlled by a OC 200) gives a new IP address from the default VLAN via DHCP to it. So far, so clear. If I then change the IP address to a fixed IP,

Hello. We have an Omada OC200 controller, 10x EAP223 (v2.0), 8x EAP225 outdoor (v3.0), SL2428P (V6.20) and SG2210MP (v5.0) switches, and several unmanaged switches. All access points, except for three

May i know how to know that i have configured the bluetooth functions on my APs and where can i find the value of UUID, Major and Minor at? Do i just generate randomly or what?

Hi all, I was now several days abroad and my ER605 on primary site was going mad. 1st two issues were relatively simple - the SDWAN link was going down - was back after rebooting router on the primary