Hi, My EAP610 v3 is much slower than expected. I switched from an AX10/AX1500 which easily pushed into the 700mbps territory within close proximity with the test client of an iPhone 13 pro (2x2 mimo).

Hello, Currently using ER605 v2 2.1.1_20230115 2 switches TL-SG2008P v1.0 2 Velop Linksys unit working on bridge mode as access points (still no budget for TPlink ceiling APs :-) ) Controller 5.8.4 ov

I have an ER7212PC with 3x PoE EAP-615 WiFi access points. The system has been working for a month until an hour ago when I upgraded the ER7212PC to firmware 1.0.2 downloaded from the tp-link UK websi

We have multiple EAP225 that run our application without issue. when we run the same application through any EAP610, our connected client devices stop receiving UDP broadcast at approximately 4 minute

I have a NAS previously assigned to a fixed IP address of 10.10.10.100. I changed the NAS IP address to 10.10.10.20. I did this by changing the NAS' static IP address to 10.10.10.20 and enabled fixed

Been meaning to post about this for a while, but, busy. When I change my network IP range when using an OC200, it would need a manual power cycle to grab the new IP scheme and come back online. Anyone