Hi, Just noticed this in my controller software: whilst the Cisco 887 it's connected to says this: I think the controller is reporting this incorrectly, as the cisco would alert if there was a mismatc

Hi, i am having a problem regarding a multiple site to site connection. I initially created a site-to-site from A to C and it goes smoothly, and i want to include site B. but i am getting an error The

My Omada Software Controller (on a Raspberry Pi) upgraded to version 5.3.1. The 2 devices I have that are on firmware 5.0.7 are not adopting anymore. Their status is alternating between provisioning a

hi, I hope that someone will help me. Is a strange Question. My network works correctly separating the IPs of the WAN (which is in truth the main LAN) from a SUB-LAN, if I ping the addresses in the W

I use Omada Software Controller, version 5.3.1. I have set up OpenVPN server to connect to and it works fine. But because it is not currently possible to set IP pool only for one IP address I would li

In the OC200 controller GUI, there is an Access Config section that has Hostname/IP, HTTPS Port For Controller and other things. I was just looking at some things on the TP Link site, and found a page