I would like to add a second remote subnet to my running IPsec tunnel (LAN-to-LAN, same WAN interface, same remote gateway). Unfortunately, in the router GUI it doesn't seem to be an option to create

Installed new firmware on a EAP225 that I inherited in our home we just moved in to which had firmware from 2019. I had a backup of the previous setup before doing this but wasn't expecting it to fact

Is there a timeline for when version 5.1.7 will be released for the hardware controllers? I'm stuck being unable to migrate sites since the software controller is running 5.1.7 and the hardware contro

Recently installed EAP610 V1 ceiling, its work fine for a couple weeks. Yesterday i config to make a new Vlan and set it to "static address 192.168.0.254". After that i cannot reach it, cannot ping to

Hello! Since I have 2 Internet Providers in my home, I want to configure "Link Backup" on my OC200/ER-605 setup. I made the following settings on OC200. Settings --> Wired Networks --> Internet WAN =

Hello, We have configure two WAN link into ER605 router however load balancing not connecting to primary WAN. It keeps on switching on secondary WAN link even though primary WAN is working. Can somebo