Deco
Hello there! Today I have the following connection: Fiber -> Bell GigaHUB -10GE->XE75 Pro -> Sattelie 1/2 via WiFi. As such the IP address of the "Main" XE75 Pro has a private address (192.168.1.123).
0Helpful
20Views
I wanted to write a little but of my experience with this Mesh system. To Start with, my home is 99% HomeKit (WiFi, Thread), with some IKEA Zigbee in the mix via Dirigera Hub. I have tried to keep it
Network ConnectivityWi-Fi 6EHomeKitHighlighted Thread
By
Jonas-Homekit
· Latest post 5 hours ago
by Jonas-Homekit
4Helpful
232Views
Hi, i just bought a Deco x50 AX3000 (3 pack) wifi 6 mesh router to upgrade from my previously owned a Deco M4 routers which worked fine. When I setup the new routers for the first time, it did a firmw
Access Point ModeFirmware UpdateNetwork Connectivity
By
xeon09
· Latest post 8 hours ago
by JanRekenaar
0Helpful
31Views
Hi, I use my Deco in Spain with an external antenna, operating in 4G and 5G. Usually, the 5G-signal works with 2-300 Mbit/s, but sometimes it drops and there is no "juice" 0 Mbit/s. I suspect it to be
Connection Preference5G
By
lh03
0Helpful
21Views
Official ReleaseOptimize The Overall App Experience on Deco XE5300/XE75/XE75 Pro
This Article applied to: Deco XE5300/XE75/XE75 Pro_V2 Firmware Download Link: Deco XE5300/XE75_V2 1.2.8_Build 20240328 (6.21 updated) Deco XE75 Pro_V2 1.2.10_build20240325 (6.21 updated) Update Advice
Firmware UpdateHighlighted ThreadOfficial
65Helpful
7340Views
Hi, I'm extremely happy with the upgrade to my wifi the deco XE75 units offered in my new home. However as soon as I installed them the wireless thermostat failed to connect to the boiler. After some
0Helpful
50Views
Hi, I bought 2 Deco M4 last week, and it's been working fine until yesterday. My set up is the Main Deco being connected to my router through ethernet, and my 2nd Deco being in my office (which is rou
Network Connectivity
1Helpful
25Views
I bought Deco X50-Outdoor, put it on my front porch, thinking I'll extend the WiFi from the Archer C7 AC1750 from my living room. Now I see I'm out of luck? Quite disapponted TBH, bought it because I
By
RokC
· Latest post 10 hours ago
by Alexandre.
1Helpful
21Views
I recently switched from a Netgear Orbi setup to a Deco X60 setup, because I was disappointed with frequent satellite conenction loss issues with the Orbi and was done with it after several years. I m
ECO Mode/Wi-Fi ScheduleFeature RequestPower consumption
By
danielschenk
0Helpful
14Views
I have four Deco XE75s in my 6000 square foot house - all connected to each other via wifi. I just upgraded from M5s. Everything is working pretty well but I have 2 wifi devices - a Sonos speaker and
0Helpful
97Views