Deco
Hello, is it possible to use a deco mesh m4 cube as an wifi-extender on the camping? my plan is to connect the m4 with my laptop. I probably need some adapter-cable with a usb-connector on one site.Th
Wi-Fi Access Control
3Helpful
106Views
Knowledge BaseHomeShield Reports Overview
Introduction At the start of each week or month, you will receive a report summarizing the previous week or month. Some users may be curious about the specific details included in these reports. This
ReportsHomeShield
By
David-TP
David-TP0Helpful
22Views
Hi I read that it's possible to remotly configure M9 using cloud access, but not finding the url to do that. Thanks.
TP-Link ID Relatedsetup
0Helpful
19Views
Hello, I have a system with two Deco X50 and 2 Deco E4R operating in a single mesh network. The ICP cable goes in to one Deco X50 unit, which shares via LAN cables the network to the other units which
Network ConnectivityInstallation
2Helpful
153Views
Hi, my new Deco BE65 triple set is now in use for some days and I noticed the system log is filling up with tons of messages. Especially every about 30 seconds these error messages are repeating: Fri
By
Malz
0Helpful
19Views
Apparently coinciding with the 3rd April update to the Deco app on Android, I am no longer receiving "connected device" alerts. Notificaitons are fully turned on on the phone, and I only have one devi
App
1Helpful
78Views
Is the authentication req from router side fxed. There was a lot of issues SONoff devices. TP-Link Deco X20-4G signals always WPA3 mixed mode with any other codech used in settings. This is confusing
0Helpful
29Views
I Recently tried to optimize my WiFi network, but get the message that Optimization failed, but interference was detected and should be addressed. Since it's impossible to set the WiFi Channels manual
Network Connectivity
1Helpful
89Views
Dear TPLink! :) I know its an issue for long time but i dont find any official info about its future... Will we get an option to modify setup on deco? This is that my Deco system is currently unusable
Network ConnectivityAccess Point ModeFeature RequestDeco Ethernet Backhaul
0Helpful
49Views
Since the last two updates of my Deco XE75 Mesh network with 3 pods the WiFi network is quite unstable. It constantly dropping WiFi clients from the network and after a few seconds they are connected
Firmware UpdateWifi Disconnect issues
By
AirMax2023
· Latest post Yesterday
by Paul_Crouch
15Helpful
719Views