
Deco

I’m struggling to set up Ethernet backhaul for my mesh network at home. I have the following equipment: • Starlink for internet • Deco XE75 Pro as the main Deco • TP-Link SG2016P switch • 2 Deco X50 P
Deco Ethernet BackhaulPoE
6Helpful
276Views

I currently have a system which has four X50 devices The main X50 is connected via ethernet to a TP-Link Switch TL-SG105S One X50 is connected to the switch and shows on the app as hard wired I have r
PoE
0Helpful
227Views

I have added a drawing of the intented setup. I ended up chosing this setup because Reolink support told me that the NVR would double as a switch. This meant that I wouldn't have to place a switch aft
Network ConnectivityPoE
By
MrMogensenDK
· Latest post 2025-03-06 22:08:50
by MrMogensenDK
2Helpful
267Views

Hello, I have been waiting patiently for wireguard vpn on my X50-PoE & X50 Outdoor but this is still not yet available. Can you confirm when this will be coming and if there is any beta software avail
Firmware UpdateVPNPoEWireGuard
By
ngem
· Latest post 2025-02-17 16:49:27
by Pascal_DECO_94
0Helpful
767Views

Below in this guide is shown examples of "Router mode" and "Access point mode": https://www.tp-link.com/en/support/faq/3484/ It doesn't show the setup I intented so before I start wiring I'd like to b
Network ConnectivityAccess Point ModeOutdoor Wi-FiPoE
By
MrMogensenDK
· Latest post 2024-12-26 17:13:47
by MrMogensenDK
2Helpful
465Views

Hi everyone. Assuming i have enought power budjet on my poe-switch IEEE802.3bt with Cat 5e cable less than 10mt. Is it possible to setup a cascade whit 3 X50-POE? IE. POE-switch ---> X50-POEn1 ---> X5
PoEX50-POE
0Helpful
292Views

I own two Deco X60 units. Currently, my mesh network looks like this (ethernet backhaul): [router] ⇒ [Deco (main)] ⇒ [Deco (satellite)] This was working fine, except the room where my router is locate
Access Point ModePoENetwork ConnectivityDeco Ethernet Backhaul
By
friendofdog
· Latest post 2024-09-13 00:37:14
by friendofdog
2Helpful
537Views