Deco M5 unit dead overnight
Deco M5 unit dead overnight
Hardware Version :
Firmware Version :
ISP :
Dear Support-Team,
this morning I realized that my master Deco M5 unit obviously died overnight. All slave units are showing a red blinking light whereas the LED of the master unit is not lit at all. I tried to power cycle the unit with no success. No life comes into the unit. I have also checked it's power supply on another working unit and the power supply is fine.
Any suggestions?
Is the unit dead? Is there any reset procedure that I might try?
Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Did a reset and it got as far as testing the connecting, etc - then when it got to optimising the network it failed.
- Copy Link
- Report Inappropriate Content
is your modem still working? it is better to contact tp-link support for help.ncudmore wrote
Hi, Got the same issue here. Suddenly the gateway unit stopped working. If I unplug the power for a couple of minutes then plug it back in the LED glows yellow for a while then turns to red flashing before finally it goes out completely. Tried swapping the psi with another one and same thing happened.
Did a reset and it got as far as testing the connecting, etc - then when it got to optimising the network it failed.
- Copy Link
- Report Inappropriate Content
@careyer Same here.... no light.... tried everything, just died.... can't get through to tech support on chat or phone...
- Copy Link
- Report Inappropriate Content
Hi, How long have you had the Deco unit and when did this issue start?
Was there any power outage recently?
By the way, did all your Deco units have no power or just one of them?
Did you also try to swap the power adapter?
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
@TP-Link it happened trying to set them up, right after purchase. All went dead, 2 came back with a reset, and 1 of the three in the pack won't come back to life. During setup it did ask if I wanted to update the firmware and I mistakenly said yes, so I wonder if they got into a weird state.
- Copy Link
- Report Inappropriate Content
@JohnSharkey is there any way I can reach support either on a call or chat or email? When I use the website there is never a response.
- Copy Link
- Report Inappropriate Content
Hi, yes, the local support email for UK is support.uk@tp-link.com;
And the support hotlink is confirmed working as well:
- 0345 147 0017
-
Fee:*Call from a UK landline costs up to 9p/min.
*Call from a UK mobile phone costs 3p to 55p/min.
*You may get free calls as part of your call package. Please check with your phone provider for the actual cost.
- E-mail:support.uk@tp-link.com
- Service Time:24 hours a day, 7 days a week
https://www.tp-link.com/uk/support/contact-technical-support/#Hotline-Support
Thank you very much.
- Copy Link
- Report Inappropriate Content
@careyer same issue with mine. How did you resolve yours?
- Copy Link
- Report Inappropriate Content
@DaleAbella I returned them
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 6177
Replies: 15
Voters 0
No one has voted for it yet.