VR600 Address Reservation Issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
To describe the context... I am the "happy" owner of a VR600 router since a few month. Happy because of the great improvement in management compare to my ancient material. And between quotes "" because the capacities of the router management has recently reach their limits.
I think that I encounter the same problem that the one described here, were I have written a message :
https://community.tp-link.com/en/home/forum/topic/99457?page=1
But I finally decide to start a new thread about VR600 for the visibility.
Identifications:
The Firmware Version is: 0.2.0 0.9.1 v0074.0 Build 170504 Rel.68210n
The Hardware Version :Archer VR600 v2 00000000
The problem :
I have successfully entered 12 devices for address reservation, and then I have had the grey box blocking everything. I cannot define more reserved address. I tried to delete one entry to replace it with a new one : impossible. Delete operation was ok, but I have now only 11 reserved addresses and it's impossible to enter a new one. Modify existing entry doesn't work neither.
I have a complete IoT network to design. A large number of entries in the address reservation table is a mandatory for my project. Actually, this VR600 is only good for trash in my case, unless guarantee could play.
Will a corrected firmware be available soon ? At least, is an ancient firmware usable to avoid this serious bug ?
Best regards,
EM.
