External antenna for tl-mr6400 (v4.0)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is it possible to connect an external outdoor antenna to this router? I would like to use this antenna: Poynting 4G-XPOL-A0001.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, please read below:
| Antenna Type | V3/APAC: 2 Internal 4G LTE Antennas V4/V2/V1: 2 Detachable 4G LTE Antennas |
|---|
The TL-MR6400 V4 has the external 4G antennas, while we do not suggest you to change antenna,cause the antennas on one device work alternately, if you want to change the external antennas on your router/AP to meet your special Wi-Fi requirements, we recommend you to replace all of them with same type of antenna other than change only one of them.
Good day.
- Copy Link
- Report Inappropriate Content
Yep, the device has the SMA Female connector type, so the SMA male connector type of the external antenna should be fine.
Besides, if you want to get better signal strength, you can consider to buy a network amplifier.
Good day.
- Copy Link
- Report Inappropriate Content
Hello, please read below:
| Antenna Type | V3/APAC: 2 Internal 4G LTE Antennas V4/V2/V1: 2 Detachable 4G LTE Antennas |
|---|
The TL-MR6400 V4 has the external 4G antennas, while we do not suggest you to change antenna,cause the antennas on one device work alternately, if you want to change the external antennas on your router/AP to meet your special Wi-Fi requirements, we recommend you to replace all of them with same type of antenna other than change only one of them.
Good day.
- Copy Link
- Report Inappropriate Content
@Kevin_Z Will Connector type SMA (Male) work with this router?
- Copy Link
- Report Inappropriate Content
Yep, the device has the SMA Female connector type, so the SMA male connector type of the external antenna should be fine.
Besides, if you want to get better signal strength, you can consider to buy a network amplifier.
Good day.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Kevin_Z My problem is not the WiFi performance, The router is placed under a massive sealing so the 4 G connection is weak. Gives a ping >158 ms on 3G.. How can I increase the 4G performance without replacing the router
- Copy Link
- Report Inappropriate Content
Is your router model TL-MR6400 v4.0? How did you verify the 3G signal is weak, is there any detailed info?
Who is the SIM card carrier? What if you put this SIM card into a phone, will it work on 4G? What is the band? You may install an LTE Discovery App on the phone to verify this, then check again what is the band when it is on the MR6400.
You can install the beta firmware we provided here to select the same band as on the phone, then monitor the LTE signal again:
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 32452
Replies: 6
Voters 0
No one has voted for it yet.