Deco M5 source signal selectable?
Is there an optimize command from the Deco App so that Deco slave units find their best signal source?
Is the signal source for slave decos selectable from the Deco App?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Is there a way to get access to the beta firmware. I have moved my deco m5s around and they're still connecting to the name
- Copy Link
- Report Inappropriate Content
@Clivelm See post # 191
- Copy Link
- Report Inappropriate Content
@TP-Link after trying this new firmware and seeing how ineffective it was to resolve this matter, I ended up selling my 3rd node and relying on only 2 moving forward. There's no point to have anything above 2 if I cant get a real mesh network with 3. Good job tp link....
- Copy Link
- Report Inappropriate Content
Thanks to @Esker pointing out the post with the links on, I've now uploaded the beta firmware on to two of my M5's and one M9.
Just waiting for a period where I am able to reboot them all, as the Network optimization appears to be doing nothing for me :-(
- Copy Link
- Report Inappropriate Content
Rebooted all deco's and now mine are connected to units much closer then the primary! Finally 😃
- Copy Link
- Report Inappropriate Content
@TP-Link Hi, I would like the beta firmware to select the best signal source for deco m5
- Copy Link
- Report Inappropriate Content
You can download the firmware using the following links:
M9 V2 beta firmware:
M5 beta firmware (For V1+2+3):
https://static.tp-link.com/beta/2021/202102/20210207/Deco_M5_1.5.1_Network_Map_Optimization_Log.zip
You then need to connect to your Deco's on their web interfaces, by visiting their IP addresses in a browser. Upload the relevant firmware to the deco, ENSURING the FW is the correct one for your Deco. As if it isn't you could brick the device....
Once done (I only did this on the two I needed to change the source on) - reboot all devices, which you can do through the deco app. Then run the network optimization through the app, and you should find they've connected to their closest node and not the primary node.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TP-Link hello, I have currently 4 decos in my mesh system of the M5 model.
im having the same problem where all my decos try to connect to the main deco instead to the closes one.
can you help please.
thank you
- Copy Link
- Report Inappropriate Content
How to apply the firmware:
https://static.tp-link.com/2020/202012/20201207/Documentation for upgrading Deco system.pdf
Please check your email for the beta firmware.
Thank you.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 52
Views: 122147
Replies: 333