Deco M5 source signal selectable?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is there an optimize command from the Deco App so that Deco slave units find their best signal source?
Is the signal source for slave decos selectable from the Deco App?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@TP-Link It looks like this beta is version 1.5.1 from the file name. My M5 units are all 1.5.3 Build 20210203 Rel. 68223
I just wanted to check before I load this beta firmware as it looks like I'm going backwards a couple of versions? (1.5.3 to 1.5.1)
Or am I reading this wrong?
Many thanks
- Copy Link
- Report Inappropriate Content
@TP-Link not working this solution for me. still it is connecting to the far away main deco insted of connecting to closest device.
you should give us manual method to sellect the source. this is ruin the whole idea of mesh concept
my main deco speed is 500 mbps
2 nd unit has almost 425 mbps
but 3 rd deco is having 42 mbps ( it connect to far away main deco too)
- Copy Link
- Report Inappropriate Content
Hi, I have sent you another firmware for Deco M5, and please have a check of your message box.
Thank you very much.
- Copy Link
- Report Inappropriate Content
@TP-Link please send selectable signal source for m5 beta
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Could I also please have a copy of the firmware.I am having the same issues. Thank you in advance
- Copy Link
- Report Inappropriate Content
@tp-link
Can you please send me a copy of the beta that works?
- Copy Link
- Report Inappropriate Content
Already sent and thank you very much.
- Copy Link
- Report Inappropriate Content
@TP-Link can I get the link to this firmware as well please having the same issue as everyone else. Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 52
Views: 114077
Replies: 333
Voters 39
