RE305 V3 using with a router in bridge mode but cant work out how to enable mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE305 V3 using with a router in bridge mode but cant work out how to enable mesh

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE305 V3 using with a router in bridge mode but cant work out how to enable mesh
RE305 V3 using with a router in bridge mode but cant work out how to enable mesh
2020-09-04 22:46:56
Model: RE300  
Hardware Version: V3
Firmware Version:

i have three re305 in same building all connected to main router (virgin media ) with the same SSID

 

but when the device roams between points there is NO seemless link and the device will hold onto the first RE305 until about 5% and then drops and then locks onto the second RE305 but can take 4 mins to lock on

 

is there a way of meshing these together

  0      
  0      
#1
Options
1 Reply
Re:RE305 V3 using with a router in bridge mode but cant work out how to enable mesh
2020-09-11 09:59:30

@AMCross 

Good day.

Sorry for the delay.

RE305 V3 itself supported OneMesh but it needs to work with TP-Link OneMesh routers.

And normally, we would not suggest to set up the extender one by one. If no other choice, please make sure the extenders are no more than 2.

So if possible, you could relocate the virgin media router in the center and put all RE305s around the router and connect all of them directly to the router;

If not, please try to set up different SSID to see if the devices could automatically choose the strongest signal;

 

And if you just bought RE305 and within the return period, it would be much better that you could replace RE305s with the Deco mesh system:

https://www.tp-link.com/home-networking/deco/

Thank you very much!

  1  
  1  
#2
Options