MR400 NO LEDs , NOT POWERING UP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2021-01-17 17:20:04

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-01-17

MR400 NO LEDs , NOT POWERING UP

2021-01-17 17:20:04

Model: Archer MR400

Hardware Version: V3

Firmware Version:

The router just didn't power up since the last restart.

The LEDs are all off.

Checked the adapter with another modem and found that adapater is working fine.

The router doesn't power on.

1 Reply

2021-01-26 12:17:30

Posts: 22924

Helpful: 5723

Solutions: 2715

Stories: 21

Registered: 2018-12-24

Re:MR400 NO LEDs , NOT POWERING UP

2021-01-26 12:17:30

Is it the original power adapter? Was there any power cut or bad weather or firmware upgrading before it fails to be powered on?

Try to hard reset it by holding the reset button or hole for 10s.

When and where did you buy this also? If nothing can make it power on correctly, you may need to contact the local tech support to check the warranty cause the device seems faulty:
https://www.tp-link.com/en/support/contact-technical-support/#Hotline-Support

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Introducing AI QoS: Elevate Your Gaming Experience on the Archer GE800 Gaming Router! Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.