AX73 doesn't have the NAT forwarding menu
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
By following the user guide to setup the NAT Forwarding > Port Forwarding, I can't find the NAT Forwarding menu:
https://www.tp-link.com/us/user-guides/archer-ax73_v1/chapter-12-nat-forwarding#ug-sub-title-1
The screenshot is from my environment:
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
In which mode you're using the device - wireless router or AP ?
Have you tried to use a different web browser to open the device's management page ? (Mozilla, Chrome), use incognito tab if necessary.
If it's in wireless router mode, and the issue persists hard reset the device (method 1) and re-configure from scratch.
- Copy Link
- Report Inappropriate Content
As in my screenshot, the System doesn't have any sub-menu.
I'm using it as a Wireless Router.
- Copy Link
- Report Inappropriate Content
Are you managing your router from your LAN or you're using a Remote Management ?
Some of the router's menu items may not be visible if you're using a remote management.
What's your network topology ? (ISP modem/router, AX73, etc.)
Have you tried a different browser for accessing the AX73 ?
- Copy Link
- Report Inappropriate Content
I'v reset router by method 1, but still cannot see the NAT forwarding menu.
By changing the browser, I can see the operation mode is Wireless Router Mode.
- Copy Link
- Report Inappropriate Content
Use Mozilla or Chrome browsers to see if any difference.
You can also install the Tether app on your mobile and configure the router through this app.
- Copy Link
- Report Inappropriate Content
I tried all options you mentioned. But the issue remains.
I still can't see the NAT forwarding menu.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Maybe one last thing you could try is if the missing pages can be accessed via direct link or not.
Just log into the router's user interface so that you see the menu and then replace the string after the # with the corresponding string for the page you want to open.
For example, if you were already on the Operation Mode menu like shown in your screenshot and the link in the browser's address bar is "192.168.0.1/webp.../inde...#operationMode", then replace the string "operationMode" with "portForwarding" to load the webpage for NAT Port Forwarding or "portTriggering" for the Port Triggering page or "openVpn" for the OpenVPN Server configuration page, etc.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1480
Replies: 10
Voters 0
No one has voted for it yet.