Pl Adapter kit TL-WPA7510 &Pl Adapter kit TL-WPA751Are they compatible?

Pl Adapter kit TL-WPA7510 &Pl Adapter kit TL-WPA751Are they compatible?
Pl Adapter kit TL-WPA7510 &Pl Adapter kit TL-WPA751Are they compatible?
2021-11-09 09:47:08 - last edited 2021-12-07 09:32:13
Model: TL-PA7017P
Hardware Version:
Firmware Version: 3.2.4_701013_171124_902

Bought Pl Adapter kit TL-WPA7510 September 2020, not sure the hardware version (where is that?)
Bought Pl Adapter kit TL-WPA751 October 2021

The description for the extender said it was compatible with all models so i think it should work. However, I cannot get the extenders to recognise the network. Any advice????

 

Thank you

0
0
#1
Options
1 Accepted Solution
Re:Pl Adapter kit TL-WPA7510 &Pl Adapter kit TL-WPA751Are they compatible?-Solution
2021-11-11 08:11:06 - last edited 2021-12-07 09:32:13

Hello @Lizat 

They are compatible, for powerline compatibility, please check this instruction for more details

How can I select the powerline device?
 

If the House Led is Off, that means the unit is not paired yet, you could add extra powerline unit one by one into existing powerline network by pair button referring to the instruction:
https://www.tp-link.com/support/faq/1081/

Note:  press Pair button only for 1 sec, Power Leds should be flashing on both powerline units in pairing process. ( if the Power Led does not blink, press it for 1 sec again) When the Powerline Led or House Leds are on, the pairing process is done.

Recommended Solution
0
0
#2
Options
1 Reply
Re:Pl Adapter kit TL-WPA7510 &Pl Adapter kit TL-WPA751Are they compatible?-Solution
2021-11-11 08:11:06 - last edited 2021-12-07 09:32:13

Hello @Lizat 

They are compatible, for powerline compatibility, please check this instruction for more details

How can I select the powerline device?
 

If the House Led is Off, that means the unit is not paired yet, you could add extra powerline unit one by one into existing powerline network by pair button referring to the instruction:
https://www.tp-link.com/support/faq/1081/

Note:  press Pair button only for 1 sec, Power Leds should be flashing on both powerline units in pairing process. ( if the Power Led does not blink, press it for 1 sec again) When the Powerline Led or House Leds are on, the pairing process is done.

Recommended Solution
0
0
#2
Options