TP-Link N300 use as Access Point with Ethernet under the same SSID

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link N300 use as Access Point with Ethernet under the same SSID

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link N300 use as Access Point with Ethernet under the same SSID
TP-Link N300 use as Access Point with Ethernet under the same SSID
2021-11-27 21:19:57 - last edited 2021-12-09 09:43:41
Model: TL-WA855RE  
Hardware Version: V1
Firmware Version: Default

Trying to configure my TP link n300 as an Access Point using the same SSID, connecting my extender and the router by Ethernet cable.  Apparently, in order to use the same SSID, I need to configure my TP-Link under a different channel so they don't create interference.  Any idea on how to do this? Cant find similar forum posts.  All ive seen is using a different SSIDs but its not what im looking for.

  0      
  0      
#1
Options
1 Accepted Solution
Re:TP-Link N300 use as Access Point with Ethernet under the same SSID-Solution
2021-12-09 09:43:09 - last edited 2021-12-09 09:45:30

Hello @Jtavio 

Sorry for the late reply. Extender working AP mode allows changing channel.
1.  Extender(in AP mode) will get a new IP address from router after being set up, and you try to use RE's IP address to login . ( extender IP address could be found on router's client list and you may need some help from router support  )

2. Or you could try to use 'tplinkrepeater.net' to access extender web page. 

How to log into the Web GUI of my brand new 11N Range Extender (new logo)?

Then go to Wireless settings to change channel. I hope this helps!

 

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:TP-Link N300 use as Access Point with Ethernet under the same SSID-Solution
2021-12-09 09:43:09 - last edited 2021-12-09 09:45:30

Hello @Jtavio 

Sorry for the late reply. Extender working AP mode allows changing channel.
1.  Extender(in AP mode) will get a new IP address from router after being set up, and you try to use RE's IP address to login . ( extender IP address could be found on router's client list and you may need some help from router support  )

2. Or you could try to use 'tplinkrepeater.net' to access extender web page. 

How to log into the Web GUI of my brand new 11N Range Extender (new logo)?

Then go to Wireless settings to change channel. I hope this helps!

 

 

Recommended Solution
  0  
  0  
#2
Options