Implemented Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Votes

Implemented Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ImplementedImplementing an ON/OFF switch for disabling OneMesh feature in Archer C64

terziyski

2021-12-12 23:22:11 - last edited 2022-10-27 09:42:17

Posts: 7133

Helpful: 5349

Solutions: 1214

Stories: 7

Registered: 2013-10-12

Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64

2021-12-12 23:22:11 - last edited 2022-10-27 09:42:17

Tags: #Onemesh

Model: Archer C64

Hardware Version: V1

Firmware Version: 1.10.0 Build 210716 Rel.51301n(4555)

This feature request is pretty much the same as the one for Archer C6 v2.

That way a user could stop broadcasting the hidden wireless networks that are visible even if the device is in AP mode (OneMesh not supported in AP mode - Q8/A8).

This inability increases unnecessary wireless emissions (interference), even when OneMesh is not used/configured by the user.

In general when implementing a major feature like OneMesh the user should be given the opportunity to turn it OFF if it won't be used or at least to revert back to a previous FW release.

It's a bit surprising to make this decision (OneMesh feature implementation without ON/OFF switch) given the number of similar feature requests concerning this issue.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

1 Accepted Solution

Kevin_Z

2022-07-25 05:32:33 - last edited 2022-07-25 05:35:24

Posts: 21750

Helpful: 5135

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64-Solution

2022-07-25 05:32:33 - last edited 2022-07-25 05:35:24

Hello @terziyski

I'm opening this thread to inform you that the latest firmware for Archer C64 has added the Onemesh ON/OFF button you are looking for, you may check for the updates and install the latest firmware on your router now, which is Archer C64(EU)_V1_1.11.30 Build 220624.

For anyone else who is looking for the Onemesh ON/OFF feature on your Onemesh router, please keep an eye on the following thread, we will update there when the option is available:

Disable Onemesh Hidden network on Onemesh Routers

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Implemented Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64

Implemented Implementing an ON/OFF switch for disabling OneMesh feature in Archer C64

Information

Voters 1

Tags