I have a Helium miner plugged into the ethernet port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I have a Helium miner plugged into the ethernet port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Helium miner plugged into the ethernet port
I have a Helium miner plugged into the ethernet port
2022-02-06 22:10:54
Model: RE450  
Hardware Version:
Firmware Version:

I have a Helium miner plugged into the ethernet port and the app doesn't show it.  How do I configure the extender so I can see it and I can port forward to port 44158?

 

  0      
  0      
#1
Options
1 Reply
Re:I have a Helium miner plugged into the ethernet port
2022-02-10 06:51:16 - last edited 2022-02-10 06:57:30

Hello @JKirk 

 

- Make sure RE450 has Internet and other devices like laptop or mobile phone could get internet 

- Devices/ clients connected to range extender will get a virtual Mac address and that virtual Mac addresses will show show up on router client list 

You could set up IP reservation for Helium miner using that virtual Mac address , then open ports for the device's IP address 

 

Here is a thread discussing the similar topic, please give it a try and let us know if it helps: 

Re:TP-Link RE450 with Helium Miner Sensecap M1-Solution

  0  
  0  
#2
Options