Home Network Community > Wi-Fi Routers > Configure Router as AP
< Wi-Fi Routers

Configure Router as AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configure Router as AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure Router as AP
Configure Router as AP
2022-10-26 18:23:43 - last edited 2022-12-02 09:30:04
Tags: #Access Point Mode #OneMesh #Feature Request
Model: Archer C80  
Hardware Version: V1
Firmware Version:

Hi,

 

I just purchased a new router from TP-Link, Archer AX72.

I wanted to convert my old router Archer C80 into a mesh device.

I have changed the operating mode to AP mode and tried to configure it to connect to the wifi, but couldn't find anywhere how to do that.

Can anyone explain how this is done?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Configure Router as AP
2022-10-26 19:10:28 - last edited 2022-10-26 22:04:20

  @Israel89 

 

You can't have two routers in OneMesh - check OneMesh FAQ - Q8/A8 and Q10/A10.

You can have C80 in AP mode (Case 1), connected to AX72 with an ethernet cable.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 297

Replies: 1

Tags

Access Point Mode OneMesh Feature Request
Related Articles
How to access configuration on TP-Link router set up as an AP
537 0
Configure C7 AP to be reached from outside
502 0
How can I connect and configure a DLINK Dir-615 as AP to a TPLINK A7 in AP mode
1998 0
AP mode link aggregation
364 0
AX 10 AP mode is not working
411 0
Archer AX10 AP mode not working
3986 0
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.