Wi-Fi Coverage RE550
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Why can't I change to maximum power in the Wi-Fi Coverage menu? Despite changing and saving, the minimum jumps in by default.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Thanks for your time and patience.
Were you able to reproduce this issue most of the time？
And have you ever enabled the EasyMesh feature on RE550?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
I tried several times and both Intermediate and Maximum cannot be enabled.
The extender works in the EasyMesh network with the Archer C80 router.
- Copy Link
- Report Inappropriate Content
@David-TP I'm having the same issue. I also have RE550 and Archer C80.
RE550 firmware version: 1.0.12 Build 220908 Rel.64762n
RE550 hardware version: RE550 1.0
C80 firmware version: 1.12.0 Build 221010 Rel.35508n(5553)
C80 hardware version: Archer C80 1.0
Whenever I try to set to use maximum power, it just goes back to the minimum. I have Easymesh and smart connect enabled.
- Copy Link
- Report Inappropriate Content
Hi, Thanks for the feedback.
After further analysis and testing, although it shows up as "minimum" on the WiFi coverage page, the real signal strength is the same as the "maximum".
And this issue will be optimized along with the firmware upgrade in the future.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP Thanks so much!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 783
Replies: 5
Voters 1
