Modem not working with Starlink
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My archer vr400 factory reset itself and now when i try to login to configure the tplink modem page says 'you are connected to starlink' and will not let me go any further.
Am not getting the network light on the modem either, starlink has been tested and is working.
Anyone know why it is doing this and how to get around it? Also, best config settings when I can get in to it.
Everything was working fine until it reset.
Just incase it is relevant, starlink is set up in shed ptpd to house, set up is as follows:
- starlink to poe to ptp nano
- ptp nano to poe to tp link
Cheers
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Sunshine thanks for your response, i did eventually get it working, starlink was blocking the IP setup page which was creating the drama. I just had to be very quick to adjust the settings. 🤦♀️
- Copy Link
- Report Inappropriate Content
Hi, you were using Wireless Router mode on the Archer VR400, right?
After it is reset to factory defaults, it is on DSL modem router mode by default, please disconnect it from your starlink network first, then refer to How to configure the AC VDSL/ADSL Modem Router as a regular wireless router to change it back to wireless router mode.
After that, please refer to How to Connect and Set up a TP-Link Router (or Third-party Router) to Starlink Internet to connect it and set it up to see if everything works fine.
- Copy Link
- Report Inappropriate Content
@Sunshine thanks for your response, i did eventually get it working, starlink was blocking the IP setup page which was creating the drama. I just had to be very quick to adjust the settings. 🤦♀️
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Chloe_S_89 Try power cycling all devices, checking physical connections, performing another factory reset, and connecting a computer directly to the modem. If the issue persists, contact TP-Link support. For optimal configuration settings, set a strong Wi-Fi password, change default login credentials, enable WPA2-PSK security, adjust wireless channel for less interference, and consider MAC address filtering. Customize settings based on your needs and connected devices.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 740
Replies: 4
Voters 0
No one has voted for it yet.