Connection par rj45 des satellites
Bonjour
j'ai un pack x 60 de 3 satellites
en mode routeur
les deux satellites sont branchés sur le principal par câble rj45
mais sur l'application je m'aperçois qu'ils sont reliés au satellite principal par wifi
dommage ?!
comment lui imposer le mode ethernet en rj45?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Since there are only 2 Ethernet ports on one Deco X60, Do you use any network switch to connect satellite Deco X60 units?
If yes, can I have the model number of the switch?
You could try to connect the satellite Deco X60 temporarily via an Ethernet cable to the main Deco X60. If the Ethernet Backhaul worked this time, it is very likely the issue is related to the switch. You could refer to Q5 and Q6 here---General questions about Ethernet Backhaul feature on your Deco.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Since there are only 2 Ethernet ports on one Deco X60, Do you use any network switch to connect satellite Deco X60 units?
If yes, can I have the model number of the switch?
You could try to connect the satellite Deco X60 temporarily via an Ethernet cable to the main Deco X60. If the Ethernet Backhaul worked this time, it is very likely the issue is related to the switch. You could refer to Q5 and Q6 here---General questions about Ethernet Backhaul feature on your Deco.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 288
Replies: 1
Voters 0
No one has voted for it yet.