Guest network not working with Deco X50 connected to Deco X50-4G
Guest network not working with Deco X50 connected to Deco X50-4G
I have a new, Deco X50-4G working in router mode using a 4G Sim. I've then got 3 X50 mesh units connected to it either wirelessly or with ethernet backhaul.
Standard wifi network works fine across the house, but I can only connect to the guest network when within range of the X50-4G unit. I assume this means the guest SSID is not being relayed through the mesh.
Is there any way to set up the guest network so it is accessible across the mesh? I'm not familiar with network setup, but this may be helpful to know: I can only see an option in the guest network to change the VLAN ID. (Defaults to 591.) I can't see an option for IPTV/VLAN in the main advanced settings.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Nice to see you again.
I don't think it is an unknown issue.
Did you experience this issue on different mobile devices when they are connected to the Guest network?
The possible explanation I could think of might be:
This device was connected to both the Guest and Main WiFi before. When it moves between two Mesh APs, it will disconnect from the original AP, and somehow, it decides the Main network of the new AP is "better" than the Guest Network.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP many thanks for your reply.
I have experienced this on many difference devices (laptop and mobile).
I doubt that's the reason: my devices don't auto-join to the main network as I use it exclusively for IoT and I have the guest network with a weaker password for our daily usage devices and guests.
I heard that some Deco devices have a dedicated IoT network but mine apparently don't, so this is the way I solved it.
Lately I have been having many issues with connectivity: websites take a very long time to resolve and I have to revert to my mobile hotspot (same carrier, also 5G, so the issue must be between the deco and my devices, I guess). If I visit a speed test website, it takes ages to load, but after loading the speeds are actually quite good (around 250 down, 20 up)
I'm a bit lost on how to debug this as networking is, by far, where I'm least comfortable but the fact is that I haven't been able to use my home network reliably.
I know it's a long shot as I'm not providing any helpful information but any suggestion you might have on solving this once and for all would be extremelly appreciated.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 836
Replies: 12
Voters 1
