Extender can’t connect to network after updating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Extender can’t connect to network after updating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Extender can’t connect to network after updating
Extender can’t connect to network after updating
2024-04-04 20:23:32
Model: RE700X  
Hardware Version: V1
Firmware Version: 1.1.4.P1 rel 78185

After updating the extender can't connect to network.

I tried to reset it and configure it again but it didn't work!

  1      
  1      
#1
Options
1 Reply
Re:Extender can’t connect to network after updating
2024-04-08 07:27:35

  @Page70 

Hi, Thank you very much for the feedback.

The firmware 1.1.4 Build 20230509 Rel. 78185 has been released for a while and I haven't seen much feedback about it.

Personally, I don't think the current issue is due to the firmware upgrade.

 

May I know the model number of the host router? Is RE700x unable to connect to either 2.4GHZ or 5GHz?

Apart from the firmware upgrade, is there any other modification recently?

 

It is also suggested to refer to the suggestions here:

Recommended settings on the host router to work well with TP-Link Range Extenders

Best regards.

 

 

 

  0  
  0  
#2
Options