OC200 unable to see EAP115 Access point
I have TPlink switch ( POE) connected to 3 Access points( EAP wall plate 115) and OC200 . The OC200 is unable to see any access point. There is no omada gateway but only TPLink small router for WAN access . NO VLAN , all basic setup. I have reset the devices multiple times but still OC200 is unable to communicate to EAP 115. Pls suggest
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Which hardware version and which firmware version do you have on the access points?
And do you have access to AP web console in stand alone mode?
- Copy Link
- Report Inappropriate Content
All EAP's are TPlink 115
Hardware Version : 4.0
Firmware Version: 5.0.5 Build 20220427 Rel. 42838(5553)
All of the EAP's and Controller are connected on single TPlink POE Switch TL-Sl1218MP ( Default config - No changes)
They all work very well in standalone mode. I had reset them ( Both Controller and EAP) multiple times but no luck .
ps: I also tried by putting Controller IP in Inform URL/IP address field of EAP system ...> Controller setting but didn't bring the positive result.
- Copy Link
- Report Inappropriate Content
go to global view, then Controller Settings,
make sure that Show Pending Devices is enabled.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
then I don't know, if the controller is on the same network as the access points, they should appear in the console.
are you sure that the access points have not been adopted into another site?
- Copy Link
- Report Inappropriate Content
Hi @MTHAREJA
Have you tried the discovery utility? Or can you PING the OC200's IP address when connecting to EAP wifi? Meanwhile, please try to PING EAP IP when wired connect to the second port of OC200.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
pretty basic.
i guess you are not in the same subnet which is the reason why they don't show up.
paste the network diagram with IP. people will help you check it.
- Copy Link
- Report Inappropriate Content
Thanks for your help and support. Complex problems always have simple solution.
The DIP switch settings on the TPLink ( TP-Sl1218-MP) switch was the root cause.
I had a simple home network with all devices on on subnet.
Thankyou for all your replies and useful tips for checks to help me out.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 698
Replies: 10
Voters 0
No one has voted for it yet.