H200, flashing status lights
Hi,
Over the last few days the status lights on my H200 hub starts flashing red and green slowly.
According to the manual this means it's "ready for setup", but it is set up and operating normally.
If I reboot it, the status light turns to solid green, as expected, but then, a day or so later it starts doing it again
As far as I can tell, nothing unusual or unexpected is happening on my network or with any of my Tapo devices.
All of my devices have the latest firmware.
I have a doorbell, a H100 and a C120 camera (although that obviously doesn't connect to the hub)
Any suggestions what might be going on?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
All green this morning! I was on wireless 🛜.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
PM sent. Having the same problem.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Upon checking, it seems you haven't applied the beta firmware. Did you email the support team for this issue separately?
What's the current firmware of your H200? Is it WiFi connected or ethernet?
- Copy Link
- Report Inappropriate Content
No, I didn't contact the support centre separately.
The current firmware is 1.3.5. Build 20240727 rel 48294
Thanks
- Copy Link
- Report Inappropriate Content
I upgraded mine to 1.3.5 Build 20240730 rel.60985. It's been more than 48hrs and the wireless connection is stable.
- Copy Link
- Report Inappropriate Content
You may send your device Mac address to me via PM. The production firmware for this issue has not yet released.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 1618
Replies: 29
Voters 1
