Archer BE230 Won't switch to satellite mode

Archer BE230 Won't switch to satellite mode

Archer BE230 Won't switch to satellite mode
Archer BE230 Won't switch to satellite mode
3 weeks ago - last edited 3 weeks ago
Model: Archer BE230  
Hardware Version: V1
Firmware Version: Latest

I want to set up a mesh and I have a BE230 router that I want to use as a satellite. I have reset it, connected to it and tried to change the onemesh setting to satellite. However, after the reboot, it still stays in main router mode.

  0      
  0      
#1
Options
4 Reply
Re:Archer BE230 Won't switch to satellite mode
3 weeks ago

  @2001ASO After changing be230 to satellite dont touch it.

dont enter it interface.

go to main and just add be230 to mesh.

  1  
  1  
#2
Options
Re:Archer BE230 Won't switch to satellite mode
a week ago

  @YuriyB I have left the BE230 and if I go to the AX6600 OneMesh setup it is not displaying any aditional devices.

  0  
  0  
#3
Options
Re:Archer BE230 Won't switch to satellite mode
a week ago

  @JohanMyburgh 

 

Hi,

 

It is not supported to add an EasyMesh satellite router to an OneMesh main router via the graphical user interface. You will have to use the "WPS" method instead. (first start WPS on the AX6600 and then within two minutes press the WPS button of the BE230)
 

  0  
  0  
#4
Options
Re:Archer BE230 Won't switch to satellite mode
a week ago
Thanks you so much. You are a superstar!!! This wworked.
  1  
  1  
#5
Options