Hi  @TPint 

VX230 is a customized device specifically designed for local Service Providers. Its software is tailored to meet the unique requirements of these providers, ensuring alignment with their specific needs. While our technical support team is adept at providing general guidance and suggestions for products with standard, generic firmware. However, due to the specialized nature of the firmware on your device, our ability to provide troubleshooting may be limited.

We can certainly offer some troubleshooting tips that may help resolve your issue. Please consider the following:

1. Usually, a device only needs to set up one internet connection type, such as dynamic IP or PPPoE. You need to confirm with the ISP which connection type to use. As for the VLAN ID, it also depends on the ISP.

2. vx230v is a modem router. Is the cable from the ISP device Ethernet cable or DSL cable? If it is the former, you need to set up Internet Connection in EWAN Router Mode. Otherwise, you need to set up Internet Connection in DSL Modem Router Mode.

For details, please refer to page 18 of the following user guide:

VX230v(EU)_User Guide

If the problem persists after trying these steps, we recommend contacting the technical support of your Service Provider who supplied the device, as they are best suited to provide the necessary assistance for your device.

  @Joseph-TP 

The entire connection is correct, the fact is that this problem occurs with many other models, both modems and TP-Link routers.
Just search here in the forum for phrases like "Recv no OFFER" and a lot of discussions will come up.

What I'm asking is if it is possible to list as URGENT the fixing of this problem, which is at the firmware level.

Could you forward it to the technical department?

Hi  @TPint 

The tech team was made aware of your issue, they will likely reach out to you via email to continue to troubleshoot your issue. Please check your email box and confirm.

  @Joseph-TP 

Yes the mail arrived.