Home Network Community > 5G/4G Routers > Port TCP 443 settings
< 5G/4G Routers

Port TCP 443 settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Port TCP 443 settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port TCP 443 settings
Port TCP 443 settings
2025-01-31 14:42:52 - last edited 2025-06-18 12:25:26
Tags: #Port Forwarding
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 1.8.0 0.9.1 v0001.0 Build 240716 Rel.60322n

I have recently lost communication between my solar invertor and the manufacturer's (Solar Edge) monitoring system.  The manufacturer has advised that I need to set TCP 443 enabled for double-ended communication.  Can you advise how I achieve this?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Port TCP 443 settings-Solution
2025-02-13 06:57:49 - last edited 2025-02-21 09:20:52

  @Portmellon 

Hi, Thank you very much for your time and patience.

Most SIM carriers used CGNAT service. Before opening the TCP 433 port, it is recommended to confirm you have had a public IPv4 address:

The IPV4 address on the MR600 needs to be the same as https://whatismyipaddress.com/

As for the port forwarding configuration, please refer to:https://www.tp-link.com/en/support/faq/2841/

 

Wait for your reply and best regards.

 

 

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for Test! ▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN ▶Deco BE65_V2_1.3.0 Added DoH & DoT, Speed Limit and Internet Backup Try to leave a Message if urgent help is required.
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:Port TCP 443 settings-Solution
2025-02-13 06:57:49 - last edited 2025-02-21 09:20:52

  @Portmellon 

Hi, Thank you very much for your time and patience.

Most SIM carriers used CGNAT service. Before opening the TCP 433 port, it is recommended to confirm you have had a public IPv4 address:

The IPV4 address on the MR600 needs to be the same as https://whatismyipaddress.com/

As for the port forwarding configuration, please refer to:https://www.tp-link.com/en/support/faq/2841/

 

Wait for your reply and best regards.

 

 

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for Test! ▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN ▶Deco BE65_V2_1.3.0 Added DoH & DoT, Speed Limit and Internet Backup Try to leave a Message if urgent help is required.
Recommended Solution
  0  
  0  
#2
Options
Re:Port TCP 443 settings
2025-07-27 19:33:43
Deco E4
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 555

Replies: 2

Tags

Port Forwarding
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.