WR702N DHCP lease too long
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR702N DHCP lease too long
Region : UnitedKingdom
Model : TL-WR702N
Hardware Version : V1
Firmware Version :
ISP :
Hi,
I have several WR702N's and need really short dhcp lease times, ideally 30 seconds or so but the options only allow me to go to 1 minute, I have tried setting the lease times to this but no matter what the setting in the AP anything connecting even up to a couple of hours later still gets the same IP, the setup I am using is as follows
1 * WR702N as an access point
5 * WR702N as clients
only three of the clients are in use at any one time and if I disconnect one from the network and wait 2 minutes I need the new client to grab the IP of the removed device, no matter what I set the dhcp lease time too it's holding IP's for hours and stopping this from happening.
Any ideas?
pod
Model : TL-WR702N
Hardware Version : V1
Firmware Version :
ISP :
Hi,
I have several WR702N's and need really short dhcp lease times, ideally 30 seconds or so but the options only allow me to go to 1 minute, I have tried setting the lease times to this but no matter what the setting in the AP anything connecting even up to a couple of hours later still gets the same IP, the setup I am using is as follows
1 * WR702N as an access point
5 * WR702N as clients
only three of the clients are in use at any one time and if I disconnect one from the network and wait 2 minutes I need the new client to grab the IP of the removed device, no matter what I set the dhcp lease time too it's holding IP's for hours and stopping this from happening.
Any ideas?
pod