@David-TP

Hello David! I have a problem with the 1.6.7 firmware, that every time the network restarts, I have to unplug the external X50-Outdoor from the power supply, because it cannot connect to the network. Until I do it, it blinks red. Otherwise, it is a good firmware and much more stable than the previous one, even if it crashes and restarts every few days. I can live with that. I went back to 1.6.4 because it's inconvenient to turn the X50-Outdoor on and off. Please pay attention to this problem. 😊

I forgot to write that I have an X50-5G, four X50s and one X50 outdoor.

BR. Miro

  @David-TP  please add doh support  & manual channels  the ai only picks channel 36 on 5 ghz   . when there over 30 routers close by there lots of interfere  would allow for better connections more speed on the network

  @David-TP 

Yes, I did  submit the log to TP link customer support.

I'm using an app on android to check on the network status, when easy-mesh feature is turned on for the deco to detect my third party easymesh router, the easymesh router will downgrade itself to 40mhz/80mhz, but deco still remains on 160mhz.

Yes I did even try to alternate between 80mhz/160mhz, but the easy mesh router still remains the same, and the channel is not on the same as deco even after clicking network optimization.

  @David-TP 

Fiberhome SR1041F AX3000.

Deco to be use as Controller

  @David-TP 

Turning on the EasyMesh function at settings will caused my third party Easy-Mesh router to fall back to 40Mhz, by default, this Fiberhome router that I'm using is AX3000 rated and can broadcast 160mhz, but with this new firmware, the easymesh becomes weird when not ethernet backhaul, as it will drop connections between the decos with this router.

And when I use ethernet backhaul, the signal and data is stable but the router goes into slow mode unless I turn off the easy mesh and use WPS to link it as a client.

  @David-TP I think I fixed my problem. It turns out that my old network was in the app and some of the devices were reflected there. I used the instructions https://community.tp-link.com/en/home/forum/topic/770972, deleted the network. And all the devices appeared on firmware 1.6.7. Maybe it's a coincidence. But it helped me

  @ARGamingPK1 logical. but why distribute firmware 1.6.4, which had errors and now they are testing 1.6.7. and 1.6.4 (non official )  was not even posted on the site?