Deco X50 missing IPv6 port forwarding in 5G router mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
July 2023 was a forum post about this - https://community.tp-link.com/en/home/forum/topic/616750
The thread has been locked for further replies. this is why i started a new one
So i am able to get a IPv6 address from the carrier when i set the mobile ISP profile to use PDP type IPv4 & IPv6, but as the settings to config IPv6 doesnt show when Operation mode is set to 4G/5G Router it creates a unstable connection. i am assuming it is because on IPv4 i have a different DNS as well but also the fact i can not config anything
i just need the config so i can get it setup so can get past CGNAT on IPv4 as i dont want to have to use a VPN or setup tailscale e.g.
does anyone have any ways to gain access to the settings or know if its in the road map for a software update
Hi, Thanks for the feedback.
I'll pass this feature request on to the senior engineer first. So far, there hasn't been a plan to add this feature.
Here is the web emulator of Archer NX200. Do you plan to have the following features:
https://emulator.tp-link.com/NX200_1.4.0_Emulator_v1.2/Emulator/index.htm
Best regards.
