Deco X50-5G no static routes?
Hello!
I've received a X50-5G recently. Unfortunatly i've checked the hardware version too late and just found out it is v1. But nevertheless, issue might be the same with v1.2 and v2.
Is there no support for static routes? I have a VPN running and need them.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, did you host a VPN server behind Deco X50-5G?
Most of the mobile service providers use CG-NAT services and assign a reserved IPV4 internet address. Do you want to set " Static Routes" for this matter?
And the 1.2.0 beta here has added " Static Routes"
Deco X50-5G_V1_1.2.0 with IoT and CPU Optimization
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Thanks! I'm using Tailscale which is already setup and running. I had problems with CG-NAT in the past but with Tailscale that is no problem, fortunatly.
Thanks for the 1.2.0 Beta hint, haven't seen that. Will give it a try even though the responses in the beta-thread don't all read very well.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP Is there another firmware i've missed with the static routes available?
- Copy Link
- Report Inappropriate Content
Hi, no, I'm afraid there hasn't been a new firmware yet
I thought 1.2.0_Beta did, but apparently, it seems only under wireless router mode instead of 5G router mode.
Sorry for the inconvenience.
Best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I mean, I do understand that the limitation is more on the APP side than due to router config.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 393
Replies: 7
Voters 1