Official Release Deco X50-5G_V1_1.2.1 Official Now Available for Installation!
This Article Applies to
Deco X50-5G_V1/V1.2
Modification and Bug fixes
- Supported locking 5G NSA Bands via Cell Lock.
- Added an External Antenna configuration entry under Wireless router mode when enabling 4G/5G Backup
- Fixed high CPU usage in certain scenarios.
- Fixed an issue where IoT devices could not be managed in some cases.
- Fixed the issue that Samsung phones sometimes can not obtain IPv6 addresses
- Improved Network stability.
Firmware Version
| Deco X50-5G_V1/V1.2 | 1.2.1_Build 20250413_Official |
Update Notice:
1. It can't be directly reverted to the official 1.1.7/1.1.5 versions via the web UI. But it can be achieved via the intermediate firmware 1.2.0_build_20241206.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hii. I updated to the latest firmware like a week ago. First week everything seems fine. Today i noticed my speed arent going above 20Mbps. I tried placing another sim, same situation. I tested both sims using my Phone, easily achieve 200mbps+-. I will downgrade back and check again if the speed changed or still the same
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi Mr.David,
Please refer below snapshot as it's showing
1.2.0 Build 20241011 and it's not showing further update.
- Copy Link
- Report Inappropriate Content
The new software is not available to automatically update yet.
You need to download it from the TP-Link website and install it manually.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@templar1996
Just noting that I experienced the exact same issue - once upgrading firmware my speeds were awful, even when trying to fix the network bands it didn't help. I tried to downgrade the firmware following TP Links advice but the router ended up being bricked - luckily I was still in warranty and TP Link helped, I have since received a new router but not upgraded the firmware. Came to this forum today to see if there was any update on stability but I think I'll stick with older firmware for now..
- Copy Link
- Report Inappropriate Content
@David-TP I updated to the latest version and everything seemed to go pear shaped. I was unaware that QOS became enabled and restricted upload and download speeds to 0.1mbps. This meant that while I was connected to the internet it was impossible to download anything. Disabling QOS resolved the issue.
- Copy Link
- Report Inappropriate Content
@David-TP I updated to the latest version and everything seemed to go pear shaped. I was unaware that QOS became enabled and restricted upload and download speeds to 0.1mbps. This meant that while I was connected to the internet it was impossible to download anything. Disabling QOS resolved the issue.
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for the feedback. It would be very helpful if other users run into a similar issue.
I did see this feedback occasionally that QoS was automatically enabled and set to 0.1( or a lower number) Mbps download/upload. It seems not to be related to a specific model.
I'll note it down first and report to the engineer for further confirmation.
Thanks a lot.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP When will version 1.2.1 be available as an regular update via Deco mobile app? From my understanding now it can be installed via web UI only. Particularly, I'm interested in information regarding Czech Republic region. Thank you for the answer.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 8831
Replies: 57
Voters 0
No one has voted for it yet.