ioT SSID up after moving to P9 as master

I've configured a network with a X50 as master and then migrate to a P9 to have CPL backhaul.
Now I have a P9 as master, X50, P9 and M5 as slaves.
The iot network I've previously configured is still alive but I can't have access to its configuration thru Deco app !!
Any hint to change that ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content

Hi, Deco P9 doesn't support IoT network, so there is an IoT entry on the Deco APP.
If you enabled the IoT network when Deco X50 is the main Deco, without disabling it before switching P9 as the main Deco, you might still detect the IoT SSID next to the satellite Deco X50 and Deco M5.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content

Hi, Deco P9 doesn't support IoT network, so there is an IoT entry on the Deco APP.
If you enabled the IoT network when Deco X50 is the main Deco, without disabling it before switching P9 as the main Deco, you might still detect the IoT SSID next to the satellite Deco X50 and Deco M5.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Thanks @David-TP
Actually, looks like a bug : iot Network was up, even if the X50 was configured as a slave.
I migrate to have a M5 as master and then I have back access to iot config.
- Copy Link
- Report Inappropriate Content
Hi,
Can you tell us what are the deco models which support IoT ?
Thanks in advance for your answer.
Best regards.
Kevin
- Copy Link
- Report Inappropriate Content
Hi, you can find the supported models here:
https://www.tp-link.com/en/home-networking/deco/?filterby=AND%7C6357
Best regards.
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 224
Replies: 4
Voters 0
No one has voted for it yet.