AV1300 kit not detected in Utility
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Using tpPLC to pair the TL-WPA8630 with TL-PA8010P as the pair button process does not work - LED blinks on the 8630 but the 8010 only flashes once and the WiFi LEDs do not come on on either device.
In tpPLC the 8630 is recognised most of the time (occasionally disappears and returns), the 8010 registered at first then dropped out - the power LED blinks once every 15secs.
Tried adding another 8010 (AV1200 series) - this was recognised initially and I could then add the AV1300 unit, but after a short time everything disappeared. I managed to reinstate the 8630 but now both 8010s show 'Unable to add the device' with the same 15sec interval for the power LED.
Are the units faulty?
Hi,
The picture below shows the relevant page from the official User Guide for the TL-PA8010, which can be downloaded from http://www.tp-link.com.
Note that in "Power-Saving Mode" the adapter will go offline and cannot be detected by software.
Hi,
The picture below shows the relevant page from the official User Guide for the TL-PA8010, which can be downloaded from http://www.tp-link.com.
Note that in "Power-Saving Mode" the adapter will go offline and cannot be detected by software.