Home Network Community > 5G/4G Routers > Wireguard with Archer MR600
< 5G/4G Routers

Wireguard with Archer MR600

Wireguard with Archer MR600

Wireguard with Archer MR600
Wireguard with Archer MR600
2025-08-18 05:38:07 - last edited 2025-09-16 01:16:10
Model: Archer MR600  
Hardware Version: V2
Firmware Version:

I would like to have some assistance with home network configuration for Wireguard. I'm running home assistant on Raspberry Pi5 with add-ons running Wireguard and DuckDNS servers. I have configured my router Archer MR600 to reserve static IP for home assistant and to have NAT forwarding / Virtual server enabled. My target is to use remote control for home assistant, but it seems that I'm not able to get connection working through the router. Any tips what to try next? Or is my router just not able to support this connection method?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Wireguard with Archer MR600-Solution
2025-08-20 18:21:01 - last edited 2025-09-16 01:16:10

Thanks for the advice. I requested information from service provider and got reply that they use strict NAT. They gave me APN address that I can use with my router. That did the trick and now I'm able to use wireguard as intended.

Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:Wireguard with Archer MR600
2025-08-20 01:43:48

  @Pykalisto 

Hi, welcome to the community.

It is suggested to check the IPV4 address on the Archer MR600 first. Most SIM ISPs use CG-NAT service, and there is no public IP for remote access.

For more details, please refer to:CG-NAT Blocks my OpenVPN and restricks the NAT type

 

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco X50_V1_1.8.0 Significantly Expanded the Client Connection Details and Added Channel Selection ▶Deco BE85 1.2.0 Enhanced Mesh Backhaul Stability and Device Roaming Experience ▶Deco BE65/BE65 Pro 1.2.0 Enhanced Mesh Network Stability and System Security ▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:Wireguard with Archer MR600-Solution
2025-08-20 18:21:01 - last edited 2025-09-16 01:16:10

Thanks for the advice. I requested information from service provider and got reply that they use strict NAT. They gave me APN address that I can use with my router. That did the trick and now I'm able to use wireguard as intended.

Recommended Solution
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 440

Replies: 2

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.